Lens Installation

Grip the top and bottom of the frame with both hands.

Gently pull up on the top of the frame while pushing the lens out from the back.

Insert the replacement lens starting at the nose bridge.

Press the replacement lens along the perimeter until it snaps securely into place.

Grip the top of the frame at the nose bridge with one hand and the lens with the other.

Pull the lens tab out of the frame's nose socket to remove the lens.

Insert the outer replacement lens tab into the frame's temple socket.

Snap the inner lens tab into the nose socket to secure the replacement lens into place.

Loosen the screw on the outer edge of the lens by the frame's temple.

Remove the lens after the screw is loose.

Insert the replacement lens into the grooves in the metal frame.

Tighten the screw back down to secure the lens.

Remove the nosepiece by squeezing it towards the center.

Pull up on the frame while pulling down on the lens to dislodge it.

Slide the new lens into a corner, bend and insert the other side into the opposite corner.

Push up on the lens until it pops into place and slide on the nosepiece.

Pull off the old rubber kit pieces and set them aside.

Use hand sanitizer to lubricate the frame.

Slip the new rubber kit pieces back on the frame.

Dry off with a microfiber cloth.

Secure frames with one hand and insert included tool into screw.

Pushing firmly to avoid stripping, turn screwdriver to the left.

Once loose, turn the frame on its side so the screw falls out.

Insert the new screw and turn the tool to the right until secure.

Using a finger to secure the bolt from the front, insert a T20 screwdriver into the bolt and twist left.

Once loose, pull the back of bolt free and use the screwdriver to push the front of the bolt out.

Insert the backside of the new bolt first, ensuring it's secure.

Pop in the front of the bolt, tightening slightly with fingers before using screwdriver to finish.